Signal Interface | Transcend Information TS16GCF600, TS8GCF600

TS8G~16GCF600		600X CompactFlash Card

Signal Interface

Electrical specifications shall be maintained to ensure data reliability. Additional requirements are necessary for Advanced Timing Modes and Ultra DMA modes operations. See next sections for additional information.

Item

Signal

Card10

Host10

-CE1

Pull-up to VCC 500 K

R

50 K

and

-CE2

shall be sufficient to keep inputs inactive

Control Signal

-REG

when the pins are not connected at the

-HIOE

host.1

-IOWR

-OE

Pull-up to VCC 500 K

R

50 K

.1,2

-WE

RESET

Pull-up to VCC 500 K

R

50 K .

1,2,9,

READY

Ω ≧

≧

Ω

.3

Status Signal

-WAIT

Pull-up to VCC R

10 K

WP

Ω ≧

≧

Ω

In PCMCIA PC Card modes Pull-up to VCC

R

10 K

.4

In True IDE mode, if DMA operation is

supported by the host, Pull-down to Gnd R

Ω ≧

≧

Ω

5.6 K

.5

-INPACK

PC Card / True IDE hosts switch the pull-up

to pull down in True≧

IDE

Ωmode if DMA

operation is supported.

The PC Card mode Pull-up may be left

active during True IDE mode if True IDE

≧

Ω

DMA operation is not supported.

Address

A[10:00]

-CSEL

Data Bus

D[15:00]

1.

Ω

≧

Card Detect

-CD[2:1]

Connected to GND in the card

Voltage Sense

-VS1

Pull-up to Vcc 10 K

R 100K .

-VS2

Battery/Detect

BVD[2:1]

Pull-up R

50 K

.3.6

Notes: 1) Control Signals: each card shall present a load to the socket no larger than 50 pF 10 at a DC current of 700 A

≧

Ω

low state and 150 A high state, including pull-resistor. The socket shall be able to drive at least the following load 10 while meeting all AC timing requirements: (the number of sockets wired in parallel) multiplied by (50 pF

with DC current 700		A low state and 150 A high state per socket).		AΩlow
2) Resistor is optional.
3) Status Signals: the socket shall present a load to the card no larger than 50 pF 10 at a DC currentΩ ≦ of≦400
Transcend Information Inc.μ	μ	μ	17	μ μ V1.0

Image 17

Transcend Information TS16GCF600, TS8GCF600 dimensions Signal Interface, Signal Card Host

Contents

Description Placement FeaturesPower Consumption Dimensions Transcend Block Diagram TS8G~16GCF600 Pin Assignments and Pin Type PC Card Memory Mode PC Card I/O Mode True IDE Mode4 PC Card Memory Mode PC Card I/O Mode Output Drive Type Input CharacteristicsInput Leakage Current Symbol Conditions Output Drive CharacteristicsOutput Drive Characteristics 600X CompactFlash Card Signal DescriptionSignal Name Dir Pin Description GND Csel Hstrobe Hdmardy Pin Description Signal NameDir Dmack ResetREG Dstrobe IordyDdmardy Electrical Specification Symbol Input Power Input Characteristics for Udma modeOutput Drive Characteristics for Udma mode Parameter Symbol Signal Card Host Signal Interface 150 a high state per socket Pull-up pin 45 BVD2 to avoid sensing their batteries as Low Table Typical Series Termination for Ultra DMA Ultra DMA Electrical RequirementsSeries termination required for Ultra DMA operation Ultra DMA Mode Cabling Requirement Speed Version 300 ns Symbol Ieee Symbol Min ns Max ns Attribute Memory Read Timing Specification Speed Version 250 ns Symbol Min ns Max ns Table Configuration Register Attribute Memory Write Timing Cycle Time Mode 250 ns 120 ns 100 ns 80 ns Symbol Common Memory Read Timing SpecificationMin Max Symbol Ieee Cycle Time Mode 250 ns 120 ns 100 ns 80 ns Common Memory Write Timing Specification Data Delay after Hioe TdHIOE TlGLQV Input Read Timing SpecificationData Delay from Wait Rising2 TdIORDY TWTHQV Wait Width Time2 TwIORDY TWTLWTH Cycle Time Mode 255 ns 120 ns 100 ns 80 ns Output Write Timing Specification T6Z True IDE PIO Mode Read/Write Timing SpecificationMode TS8G~16GCF600 True IDE Multiword DMA Mode Read/Write Timing Specification TS8G~16GCF600 PC Card MEM PC Card IO Mode True IDE Ultra DMA Mode Read/Write Timing SpecificationMode Udma True IDE Mode Udma TS8G~16GCF600 Name Name Comment Min Max Name Mode Mode414.7 72.9 50.9 Min Max Name Multiple Function CompactFlash Storage Cards Card ConfigurationREG Selected Space Dmarq Dmack Stop Hioe Dmardy StrobeDMA Inpack REG Hiow Wait Hioe CMD DMA CMD REG Attribute Memory FunctionTable Attribute Memory Function Configuration Option Register Base + 00h in Attribute Memory TS8G~16GCF600 Pin Replacement Register Base + 04h in Attribute Memory Socket and Copy Register Base + 06h in Attribute Memory Transfer Function Table Pcmcia Mode I/O FunctionDMA CMD REG -CE2 Inpack REG Hiow Wait Hioe CMD A00 Table PC Card I/O Mode Udma FunctionDmarq Dmack Stop Hioe Wait DMA A10 Table Common Memory Function Common Memory Transfer FunctionDMA REG CE2 CE1 D15-D8 True IDE Mode I/O Transfer Function Metaformat Overview CF-ATA Drive Register Set Definition and Protocol Table Primary and Secondary I/O Decoding Primary and Secondary Address Configurations Table Contiguous I/O Decoding Contiguous I/O Mapped Addressing Memory Mapped Addressing True IDE Mode Addressing Data Register Address 1F0h170hOffset 0,8,9 CF-ATA Registers Sector Count Register Address 1F2h172h Offset Feature Register Address 1F1h171h Offset 1, 0Dh Write OnlySector Number LBA 7-0 Register Address 1F3h173h Offset Cylinder Low LBA 15-8 Register Address 1F4h174h Offset TS8G~16GCF600 Device Control Register Address 3F6h376h Offset Eh Card Drive Address Register Address 3F7h377h Offset Fh Command Code CF-ATA Command Set Definitions Execute Drive Diagnostic 90h Check Power Mode 98h or E5hBit Command Cyl High Cyl Low Sec Num Sec Cnt Feature Erase Sectors C0h Transcend Information IncFlush Cache E7h Format Track 50h Word Default Total Data Field Type Information Drive Cyl High Cyl Low Sec Num Sec Cnt FeatureIdentify Device Ech Bytes Command sets supported PIO data transfer cycle timing modeXXXXh Command sets enabled Ultra DMA Mode Supported and Selected CF Advanced True IDE Timing Mode Capability and Setting Word 0 General ConfigurationCF Advanced PC Card I/O and Memory Timing Mode Capability Key management schemes supported Word 3 Default Number of Heads Word 1 Default Number of CylindersWord 6 Default Number of Sectors per Track Word 49 Capabilities Bit 13 Standby Timer Total Sectors Addressable in LBA Mode Multiple Sector SettingCurrent Number of Cylinders, Heads, Sectors/Track Current Capacity Word 68 Minimum PIO transfer cycle time with Iordy Words 82-84 Features/command sets supportedRecommended Multiword DMA transfer cycle time Word 88 Ultra DMA Modes Supported and Selected Words 85-87 Features/command sets enabled Word 128 Security Status Bit 8 Security Level Word 91 Advanced power management level valueWord 89 Time required for Security erase unit completion Value Maximum PIO mode timing selected Word 160 Power Requirement DescriptionValue Maximum Multiword DMA timing mode supported Additional Requirements for CF Advanced Timing Modes Value Maximum Pcmcia IO timing mode Supported Value Current PIO timing mode selectedValue Maximum Memory timing mode Supported Current Multiword DMA timing mode selected Value PC Card Memory or I/O Udma timing mode Selected Value Maximum PC Card I/O Udma timing mode SupportedValue Maximum PC Card Memory Udma timing mode Supported Idle Immediate 95h or E1h Idle 97h or E3hInitialize Drive Parameters 91h Drive Cyl High Cyl Low Sec Num Sec Cnt Read DMA C8h Read Long Sector 22h or 23h NOP 00hRead Buffer E4h TS8G~16GCF600 Request Sense 03h Seek 7Xh Set Features EFh Feature Supported TS8G~16GCF600 Translate Sector Information Standby Immediate 94h or E0h Translate Sector 87h Wear Level F5h Write Buffer E8h Write DMA CAh TS8G~16GCF600 TS8G~16GCF600 NOP Error PostingBBK UNC Idnf Abrt Amnf Drdy DWF DSC Corr ERR S. Table Capacity Transcend Product Capacity CompactFlash Card Ordering Information