Transcend Information TS16GCF600, TS8GCF600 dimensions Reg, Dmack, Reset

TS8G~16GCF600				600X CompactFlash Card
	Signal Name	Dir.	Pin	Description
-REG		I	44	This signal is used during Memory Cycles to distinguish between Common
				Memory and Register (Attribute) Memory accesses. High for Common Memory,
(PC Card Memory Mode– Except
				Low for Attribute Memory.
Ultra DMA Protocol Active)
Attribute Memory Select				In PC Card Memory Mode, when Ultra DMA Protocol is supported by the host
				and the host has enabled Ultra DMA protocol on the card the, host shall keep the
				-REG signal negated during the execution of any DMA Command by the device.
-REG				The signal shall also be active (low) during I/O Cycles when the I/O address is
				on the Bus.
(PC Card I/O Mode –Except Ultra
DMA Protocol Active)				In PC Card I/O Mode, when Ultra DMA Protocol is supported by the host and the
				host has enabled Ultra DMA protocol on the card the, host shall keep the -REG
				signal asserted during the execution of any DMA Command by the device.
-DMACK				This is a DMA Acknowledge signal that is asserted by the host in response to
(PC Card Memory Mode when				(-)DMARQ to initiate DMA transfers.
Ultra DMA Protocol Active)				In True IDE Mode, while DMA operations are not active, the card shall ignore the
DMACK
				(-)DMACK signal, including a floating condition.
(PC Card I/O Mode when Ultra
DMA Protocol Active)				If DMA operation is not supported by a True IDE Mode only host, this signal
-DMACK				should be driven high or connected to VCC by the host.
(True IDE Mode)				A host that does not support DMA mode and implements both PC Card and
				True-IDE modes of operation need not alter the PC Card mode connections
				while in True-IDE mode as long as this does not prevent proper operation all
				modes.
RESET		I	41	The CompactFlash Storage Card is Reset when the RESET pin is high with the
(PC Card Memory Mode)				following important exception:
				The host may leave the RESET pin open or keep it continually high from the
				application of power without causing a continuous Reset of the card. Under
				either of these conditions, the card shall emerge from power-up having
				completed an initial Reset.
				The CompactFlash Storage Card is also Reset when the Soft Reset bit in the
				Card Configuration Option Register is set.
RESET				This signal is the same as the PC Card Memory Mode signal.
(PC Card I/O Mode)
-RESET				In the True IDE Mode, this input pin is the active low hardware reset from the
(True IDE Mode)				host.
VCC		--	13,38	+5 V, +3.3 V power.
(PC Card Memory Mode)
VCC				This signal is the same for all modes.
(PC Card I/O Mode)
VCC				This signal is the same for all modes.
(True IDE Mode)
Transcend Information Inc.				13
				V1.0