DigiTech GSP1101 Seamless Time, LFO Settings, Preset Level, To change the level of a preset

Using the GSP1101

Press the Back button (next to the Edit/Select knob) to back out of sub-menus, and eventually return to the preset’s main screen (thus ending the editing session).The Back button DOES NOT cancel changes you’ve made to a preset or menu, but does cancel the Store procedure.

Note that you must save any changes you make while editing (using the Store button), or your changes will be lost when the GSP1101 is turned off or a new preset is selected.

Seamless Time

Presets in the GSP1101 that use delays and reverbs can have their repeats and reverb tails heard to completion even after changing to a new preset. This is referred to as a “Seamless” preset change. For more information, see page 41.

LFO Settings

The GSP1101 has 2 programmable LFOs (Low Frequency Oscillators) per preset that can be assigned to automatically control parameters. The LFO will automatically control the parameter between the minimum and maximum range as defined by the Expression Link using the LFO waveform shape and speed set in this menu. For more information, see page 19.

Preset Level

Each of the presets in the GSP1101 can have a specified programmed level.

To change the level of a preset

1.Press the Edit/Select knob twice to enter the preset edit screen.

2.Turn the Edit/Select knob until the Preset Level menu is selected and press the knob.

3.Use the Edit/Select knob to change the preset level.

4.Store these changes to the preset using the Store procedure if these changes are to be recalled later.

19

GSP1101 Owner’s Manual