CoPilot® 2002 Quick Start

If you're in a hurry to begin using CoPilot 2002:

1.Install Application: Boot up your computer. After Windows® (95, 98, NT®, 2000, ME®) has finished booting up, install CoPilot 2002 by placing the Install CD into your CD-ROM drive. Select Install CoPilot from the pop-up menu and follow the on-screen instructions. (If the Installation menu does not automatically appear, see Installation on page 5).

NOTE: You must uninstall any previous versions of CoPilot before installing CoPilot 2002.

2.Install Speech: After CoPilot has been installed, you will be prompted to install speech software. Click OK and follow the on-screen instructions.

NOTE: You must install speech to enable CoPilot's two-way voice technology.

3.Install Data: You can install either one or both Data CDs to your hard drive, depending on your preference. To install both CDs will require about 1 GB of space. Place the East or West Data CD into the CD-ROM drive and follow the installation instructions.

4.Attach GPS Receiver: Plug the GPS receiver into your laptop (see page 9-10).

Serial: If you are using a GPS receiver with a serial connection, attach the receiver to both the serial port and the PS/2 port.

USB: If you are using a receiver with a USB connection simply plug the receiver into the USB port.

5.Verify Computer Settings: Make sure the date and time are set correctly on your computer. This is extremely important for CoPilot to function properly. To check and/or change the date and time, go to the Windows Start button, Settings, Control Panel, Date/Time.

Page 2
Image 2
TravRoute manual CoPilot 2002 Quick Start