Contents | Trek 6i, 8i specification

Contents
Safety and general guidelines	1
Functions	2
Installation	4
Placing the computer on the handlebar	5
Placing the magnet	7
Attaching the computer wire	8
Attaching the sensor	9
Easy setup (ReSet)	11
ReStart- Getting ready to ride	17
Additional information	18
Troubleshooting	19
Replacing the battery	20
Setting custom wheel size	22
Limited Warranty	25

ii

Image 2

Trek 6i, 8i owner manual Contents

Contents

Trek Incite 6i 920 Contents Safety and general guidelines Watch the road when riding Functions Function Explanation Wheel Installation Mount To install the computer on handlebar Placing the computer on the handlebar To install the computer on the stem Make sure the com- puter cannot be bounced off To install the wheel magnet Placing the magnet Attaching the computer wire To attach the computer wire To install the sensor Attaching the sensor Tighten the nylon ties and trim the excess length Figure Easy setup ReSet Using the buttons Set To set the computer To set 6i wheel size To set 8i wheel size Select wheel screen Cycle Mode to TRP To select the wheel for use To set Clock Clock screen ReStart- Getting ready to ride To ReStart set the Trip data to zero Additional information Changing modeUsing the computer in wet weather Removing the computer from the computer base Troubleshooting Replacing the battery To replace the battery Be careful to avoid losing the rubber O-ring seal Setting custom wheel size Selecting the custom value 4-digit number Push Set To measure rollout for wheel size Measuring rollout for wheel size This warranty does not cover Limited WarrantyThis warranty covers