Manuals / Trek / Fitness & Sports / Bicycle

Trek 8i Hold Set, The left-hand digit flashes, The right-had digit changes, Push Set, Cycle Mode

Models: 6i

1 27

Page 25

ODO	Set
TME
AVG
MAX
TRP

Mode

3.Cycle Mode through the wheel sizes to the 4-digit number

4.Push Set•

The left-hand digit flashes.

5.Cycle Mode

The right-had digit changes.

6. Push Set• to select.

The second digit flashes.

7.Repeat steps 5 and 6 to select all four wheel-size digits.

8.Hold Set•

The computer returns to current speed.

Setting Custom Wheel Size

Page 25

Image 25

Trek 8i Hold Set, The left-hand digit flashes, The right-had digit changes, The second digit flashes, Push Set, Cycle Mode

Contents

Bicycle Computer Owner’s Manual Attn Customer ServiceTrek Bicycle Corporation 801 W. Madison StreetContents Figure 1- Watch the road when riding Safety and general guidelinesFigure 2- Keep the wire out of the spokes Safety and General guidelinesFunction FunctionsExplanation SPEED Stem mount InstallationHandlebar mountPlacing the computer on the handlebar To install the computer on handlebar31.8mm bars large clamp 25.4mm and 26.0mm small clamp To install the computer on the stem Placing the magnet To install the wheel magnetTo attach the computer wire Attaching the computer wireAttaching the sensor To install the sensorThe sensor can be rotated around the fork about 45 degrees 5. Tighten the nylon ties and trim the excess length Figure 10 InstallationFigure 10- Trim excess nylon tie length Easy setup ReSet Mode Using the buttonsTo set 6i wheel size To set the computer2. Hold Set 3. Cycle ModeNote If you want to set a custom wheel size, go to page 24 now To set 8i wheel sizeThe Wheel Size changes The computer returns to current speed5. Cycle Mode To select the wheel for use1. Cycle Mode to TRP The wheel size changes7. Cycle Mode To set Clock“12” or “24” flashes 12 and 24 interchange on the screenReStart- Getting ready to ride The Max setting ReStarts at ‘0’To ReStart set the Trip data to zero 3. Hold ModeAdditional information Using the computer in wet weatherChanging mode Removing the computer from the computer baseTroubleshooting To replace the battery Replacing the battery4. Lift the battery cover, exposing the battery Be careful to avoid losing the rubber O-ring sealSelecting the custom value 4-digit number Setting custom wheel sizeWheel size appears To set the computerThe left-hand digit flashes 8. Hold SetThe right-had digit changes The second digit flashesTo measure rollout for wheel size This warranty covers Limited WarrantyThis warranty does not cover