Be careful to avoid losing the rubber O-ring seal | Trek 8i, 6i

4.Lift the battery cover, exposing the battery.

Be careful to avoid losing the rubber O-ring seal.

5. Remove the old battery.

It may be possible to shake the battery out. Otherwise, carefully pry the battery up with a thin tool or knife blade.

6.Insert the new battery with the ‘cross’ and identifying label pointing up (Figure 17).

7.Replace the battery cover (and O-ring seal) and turn one-quarter turn clockwise.

Figure 17- The ‘cross’ on the bat- tery points up

Replacing the Battery

21

Image 23

Trek 8i, 6i owner manual Be careful to avoid losing the rubber O-ring seal

Contents

920 Trek Incite 6i Contents Watch the road when riding Safety and general guidelines Function Explanation Functions Wheel Mount Installation Placing the computer on the handlebar To install the computer on handlebar Make sure the com- puter cannot be bounced off To install the computer on the stem Placing the magnet To install the wheel magnet To attach the computer wire Attaching the computer wire Attaching the sensor To install the sensor Tighten the nylon ties and trim the excess length Figure Easy setup ReSet Set Using the buttons To set 6i wheel size To set the computer Select wheel screen To set 8i wheel size To select the wheel for use Cycle Mode to TRP Clock screen To set Clock To ReStart set the Trip data to zero ReStart- Getting ready to ride Removing the computer from the computer base Changing modeUsing the computer in wet weather Additional information Troubleshooting To replace the battery Replacing the battery Be careful to avoid losing the rubber O-ring seal Selecting the custom value 4-digit number Setting custom wheel size Push Set Measuring rollout for wheel size To measure rollout for wheel size This warranty does not cover Limited WarrantyThis warranty covers