Manuals / Trek / Fitness & Sports / Bicycle

Trek 8i, 6i owner manual Troubleshooting

Models: 6i

1 27

Page 21

Troubleshooting

The Incite 6i computer is designed to be easy to install and maintain. However, computers occasionally have problems. Table 3 shows some possible problems, causes, and solutions:

Table 3- Common problems and solutions

Blank screen	Computer is in shipping mode. Push a button.

	Battery is dead, or installed incorrectly. Reinstall good battery.

Erratic data	Magnet misaligned or too far away. Re-adjust magnet and sensor placement.

	Battery power is low. Replace battery.

No current speed	Magnet misaligned or too far away. Re-adjust magnet and sensor placement.

Speed is incorrect.	Wheel size is incorrect. Reset computer.

	Sensor is not reading magnet properly. Readjust magnet and sensor alignment.

Troubleshooting 19

Page 21

Image 21

Trek 8i, 6i owner manual Troubleshooting

Contents

Bicycle Computer Owner’s Manual Attn Customer ServiceTrek Bicycle Corporation 801 W. Madison StreetContents Figure 1- Watch the road when riding Safety and general guidelinesFigure 2- Keep the wire out of the spokes Safety and General guidelinesFunctions FunctionExplanation SPEED Stem mount InstallationHandlebar mountTo install the computer on handlebar Placing the computer on the handlebar31.8mm bars large clamp 25.4mm and 26.0mm small clamp To install the computer on the stem Placing the magnet To install the wheel magnetTo attach the computer wire Attaching the computer wireTo install the sensor Attaching the sensorThe sensor can be rotated around the fork about 45 degrees 10 Installation 5. Tighten the nylon ties and trim the excess length FigureFigure 10- Trim excess nylon tie length Easy setup ReSet Mode Using the buttonsTo set 6i wheel size To set the computer2. Hold Set 3. Cycle ModeNote If you want to set a custom wheel size, go to page 24 now To set 8i wheel sizeThe Wheel Size changes The computer returns to current speed5. Cycle Mode To select the wheel for use1. Cycle Mode to TRP The wheel size changes7. Cycle Mode To set Clock“12” or “24” flashes 12 and 24 interchange on the screenReStart- Getting ready to ride The Max setting ReStarts at ‘0’To ReStart set the Trip data to zero 3. Hold ModeAdditional information Using the computer in wet weatherChanging mode Removing the computer from the computer baseTroubleshooting To replace the battery Replacing the battery4. Lift the battery cover, exposing the battery Be careful to avoid losing the rubber O-ring sealSelecting the custom value 4-digit number Setting custom wheel sizeWheel size appears To set the computerThe left-hand digit flashes 8. Hold SetThe right-had digit changes The second digit flashesTo measure rollout for wheel size Limited Warranty This warranty coversThis warranty does not cover