ReStart- Getting ready to ride | Trek 8i, 6i guide

ODO	Set
TME
AVG
MAX
TRP

Mode

ReStart- Getting ready to ride

Your computer stores data for two intervals- since last ReSet and since last ReStart. ReSet sets ALL data to zero. ReStart sets only the Trip data to zero.

The trip modes include

•TRP

•TME

•MAX

This operation sets all four values to zero, allowing the computer to display information for a single ride.

MH

MAX

Figure 15- MAX screen

To ReStart (set the Trip data to zero)

1.Cycle Mode to TRP (Figure 15).

2.Hold Set•, and do not let up until after completing step 3.

3.Hold Mode.

The Max setting ReStarts at ‘0’.

ReStart 17

Image 19

Trek 8i, 6i owner manual ReStart- Getting ready to ride, To ReStart set the Trip data to zero

Contents

920 Trek Incite 6i Contents Watch the road when riding Safety and general guidelines Function Explanation Functions Wheel Mount Installation Placing the computer on the handlebar To install the computer on handlebar Make sure the com- puter cannot be bounced off To install the computer on the stem Placing the magnet To install the wheel magnet To attach the computer wire Attaching the computer wire Attaching the sensor To install the sensor Tighten the nylon ties and trim the excess length Figure Easy setup ReSet Set Using the buttons To set 6i wheel size To set the computer Select wheel screen To set 8i wheel size To select the wheel for use Cycle Mode to TRP Clock screen To set Clock To ReStart set the Trip data to zero ReStart- Getting ready to ride Removing the computer from the computer base Changing modeUsing the computer in wet weather Additional information Troubleshooting To replace the battery Replacing the battery Be careful to avoid losing the rubber O-ring seal Selecting the custom value 4-digit number Setting custom wheel size Push Set Measuring rollout for wheel size To measure rollout for wheel size This warranty covers Limited WarrantyThis warranty does not cover