Manuals / Trek / Fitness & Sports / Bicycle

Trek 6i, 8i owner manual Installation, Stem mount, Handlebar, Speed sensor

Models: 6i

1 27

Download 27 pages 11.22 Kb

Page 6

Image 6

Installation

Stem mount

	Handlebar	Speed sensor
	mount	Speed sensor
	mount

Figure 3- Location on bicycle of sensors and computer

Tools needed:

•Electrical tape

•Slot-type screwdriver

•Phillips-type screwdriver

•Scissors

Installation

Page 6

Image 6

Trek 6i, 8i owner manual Installation, Stem mount, Handlebar, Speed sensor

Contents

Trek Bicycle Corporation Attn Customer ServiceBicycle Computer Owner’s Manual 801 W. Madison StreetContents Figure 2- Keep the wire out of the spokes Safety and general guidelinesFigure 1- Watch the road when riding Safety and General guidelinesFunctions FunctionExplanation SPEED Handlebar InstallationStem mount mountTo install the computer on handlebar Placing the computer on the handlebar31.8mm bars large clamp 25.4mm and 26.0mm small clamp To install the computer on the stem To install the wheel magnet Placing the magnetAttaching the computer wire To attach the computer wireTo install the sensor Attaching the sensorThe sensor can be rotated around the fork about 45 degrees 10 Installation 5. Tighten the nylon ties and trim the excess length FigureFigure 10- Trim excess nylon tie length Easy setup ReSet Using the buttons Mode2. Hold Set To set the computerTo set 6i wheel size 3. Cycle ModeThe Wheel Size changes To set 8i wheel sizeNote If you want to set a custom wheel size, go to page 24 now The computer returns to current speed1. Cycle Mode to TRP To select the wheel for use5. Cycle Mode The wheel size changes“12” or “24” flashes To set Clock7. Cycle Mode 12 and 24 interchange on the screenTo ReStart set the Trip data to zero The Max setting ReStarts at ‘0’ReStart- Getting ready to ride 3. Hold ModeChanging mode Using the computer in wet weatherAdditional information Removing the computer from the computer baseTroubleshooting Replacing the battery To replace the batteryBe careful to avoid losing the rubber O-ring seal 4. Lift the battery cover, exposing the batteryWheel size appears Setting custom wheel sizeSelecting the custom value 4-digit number To set the computerThe right-had digit changes 8. Hold SetThe left-hand digit flashes The second digit flashesTo measure rollout for wheel size Limited Warranty This warranty coversThis warranty does not cover