Manuals / Trek / Fitness & Sports / Bicycle

Trek 8i, 6i owner manual To select the wheel for use, Cycle Mode to TRP, The wheel size changes

Models: 6i

1 27

Page 17

ODO	Set
TME
AVG
MAX
TRP

Mode

5.Cycle Mode

The wheel size changes.

6. Hold Set• to select.

The computer returns to current speed.

To set the second wheel size, repeat the instructions, but select the other Wheel Select icon.

To select the wheel for use

1.Cycle Mode to TRP

2.Hold the left Mode and the right Mode together.

The Wheel Select icon changes (Figure 13). Repeat step 2 to change again.

Easy setup (ReSet)

Page 17

Image 17

Trek 8i To select the wheel for use, Cycle Mode to TRP, The wheel size changes, The computer returns to current speed

Contents

Bicycle Computer Owner’s Manual Attn Customer ServiceTrek Bicycle Corporation 801 W. Madison StreetContents Figure 1- Watch the road when riding Safety and general guidelinesFigure 2- Keep the wire out of the spokes Safety and General guidelinesExplanation FunctionsFunction SPEED Stem mount InstallationHandlebar mount31.8mm bars large clamp 25.4mm and 26.0mm small clamp To install the computer on handlebarPlacing the computer on the handlebar To install the computer on the stem Placing the magnet To install the wheel magnetTo attach the computer wire Attaching the computer wireThe sensor can be rotated around the fork about 45 degrees To install the sensorAttaching the sensor Figure 10- Trim excess nylon tie length 10 Installation5. Tighten the nylon ties and trim the excess length Figure Easy setup ReSet Mode Using the buttonsTo set 6i wheel size To set the computer2. Hold Set 3. Cycle ModeNote If you want to set a custom wheel size, go to page 24 now To set 8i wheel sizeThe Wheel Size changes The computer returns to current speed5. Cycle Mode To select the wheel for use1. Cycle Mode to TRP The wheel size changes7. Cycle Mode To set Clock“12” or “24” flashes 12 and 24 interchange on the screenReStart- Getting ready to ride The Max setting ReStarts at ‘0’To ReStart set the Trip data to zero 3. Hold ModeAdditional information Using the computer in wet weatherChanging mode Removing the computer from the computer baseTroubleshooting To replace the battery Replacing the battery4. Lift the battery cover, exposing the battery Be careful to avoid losing the rubber O-ring sealSelecting the custom value 4-digit number Setting custom wheel sizeWheel size appears To set the computerThe left-hand digit flashes 8. Hold SetThe right-had digit changes The second digit flashesTo measure rollout for wheel size This warranty does not cover Limited WarrantyThis warranty covers