Manuals / TRENDnet / Computer Equipment / Network Card

TRENDnet TEW-603PI manual Working with Profiles, Click Profile

Models: TEW-603PI

1 44

Download 44 pages 55 Kb

Page 9

Working with Profiles

The Link Information pane provides information on your current connection. This same pane shows at the bottom of all screens so you are always aware of your connection status.

	WHEN THE TEW-603PIIS NOT CONNECTED TO YOUR COMPUTER, MOST
	SETTINGS IN THE WIRELESS CLIENT UTILITY ARE UNAVAILABLE. SETTINGS OR
NOTE	BUTTONS THAT ARE NOT AVAILABLE ARE GRAYED OUT.

Working with Profiles

A profile is a record of the configuration you use to connect to a particular access point. Without profiles, you would have to reconfigure the TEW-603PI each time you change access points. Using the Profile screen you can configure the TEW-603PI to access your home network and your office network. Each configuration is saved as a profile. Then when you go from the office to your home you just select the appropriate profile.

CREATING A PROFILE

Refer to the following to add a profile.

1.Click Profile.

2. Click Add. The Wireless Client Utility Profile Wizard opens.

9

Image 9

Contents

Page IMPORTANT NOTE FCC Radiation Exposure Statement Federal Communication Commission Interference StatementCE Mark Warning Hardware and Wireless Utility Table of ContentsExploring the Wireless Client Utility Screens Configuring Wireless SecurityGetting Started with the TEW-603PI About Your Wireless MIMO PCI Adapter Hardware and Wireless UtilityPackage Content System RequirementProduct Outline Wireless MIMO PCI AdapterSide view of the PCI Adapter from bracket Overview of the Wireless Client Utility The Network Screen The Profile Screen The SiteSurvey ScreenThe Options Screen The Version Screen 1. Click Profile Working with Profiles3. Type a descriptive name for the profile such as Home or CoffeShop 7. Click Next. The WLAN Security Configuration screen appears 9. Click Next 1. Open the Wireless Client Utility and click Profile 2. Select the profile you want to modify and click PropertiesMODIFYING PROFILES WEP Wired Equivalent Privacy WPA-PSK/WPA2-PSK WPA/WPA2Use DHCP Use static IP belowChecking for Available Access Points 1. Open the Wireless Client Utility and click Options Disabling the Wireless Client UtilityPage The Network Screen Exploring the Wireless Client Utility ScreensThe Network Screen The Profile Screen The SiteSurvey Screen The Options Screen The Version ScreenSecurity ” Shows the current network IP address The Profile Screen The SiteSurvey Screen DETAILED INFO. SCREEN The Options Screen The Version Screen Configuring Security Configuring Wireless Security2. Click the drop-down arrow at Security Mode and choose WEP 1. In the Properties window, click WLAN Security3. Click the Use Static WEP checkbox Select the encryption to match your access point CONFIGURING WPA & WPA2 Refer to the following to configure WPA / WPA21. Click the drop-down arrow at Security Mode and choose WPA / WPA2 CONFIGURING WPA-PSK & WPA2-PSK 4. Type in a unique User ID and Password under User Information Check this box if your network requires user certification and CONFIGURING 802.1X - EAP-TLS Glossary USER AUTHENTICATION SSIDTEMPORAL KEY INTEGRITY PROTOCOL TKIP Maintenance See “Maintenance” See “Troubleshooting”Appendix 3. Click Next in the Choose Destination Location screen Adapter - UninstallPROBLEM TroubleshootingPROBLEM CORRECTIVE ACTIONPROBLEM Problems Communicating With Other ComputersCORRECTIVE ACTION The TEW-603PIAd-Hoc IBSS Verify that the peer computers is turned on Limited Warranty OF THE INTENDED USE, OR BY ACCIDENT, FIRE, LIGHTNING, OR OTHER HAZARD