Tripp Lite MT-SE-37/02 owner manual Two 3.5 Diskettes, Configuration Cable, Power Supply

Tripp Lite

Serial Port

The SNMP Solo uses this port for configuration during installation or for communications during normal operations.

Two 3.5” Diskettes

Your package contains two 3.5” MIB diskettes—one in DOS format and one in TAR format. These diskettes contain the UPS MIB file. Copy the MIB file to the appropriate NMS MIB directory for the UPS connected to your SNMP Solo.

The DOS disk also contains a copy of the programmed image file and the downloaded .exe program. See the Upload Firmware section for further explanation of these files.

Configuration Cable

Your package contains a cable labeled SM-SER-117A, female- to-female. Use this cable to connect the SNMP Solo serial port and a dumb terminal or PC for configuration. When you configure the SNMP Solo, be sure to set the DIP switch to the proper setting. Any dumb terminal or terminal emulation package, such as Microsoft Windows’ Terminal will work fine.

Power Supply

The two types of power supplies offered are:

Power Supply Type	Input	Output
Wall Cube	120 VAC, 60 Hz	9 VDC, 1 amp
Universal	230 VAC, 50 Hz	9 VDC, 1 amp

WARNING: If you are using a power supply other than the one supplied with the SNMP Solo, be sure that the polarity of the new power supply is correct. If the polarity of the new power supply is incorrect, you may run the risk of damaging the adapter.

SNMP Solo Package 5