Tripp Lite
Final Installation
Now that you have completed Configuration you are ready to connect the SNMP Solo to your UPS and to the network. Follow these steps to complete the installation:
1.Turn DIP switch 1 on the SNMP Solo from the DOWN (ON) position to the UP (OFF) position.
2.Disconnect the configuration cable from the SNMP Solo adapter and the terminal or PC. Store this cable for future use.
3.Disconnect the SNMP Solo from the power supply.
4.Locate the cable labled “73743”. This is the UPS interface cable. Place the SNMP Solo close enough to the UPS so the UPS interface cable can connect the SNMP Solo’s serial port and the UPS’s serial port.
5.Connect the labelled end of the UPS interface cable to the SNMP Solo’s serial port. Connect the other end to the UPS’s serial port.
6.Connect the SNMP Solo to the Ethernet
7.Reconnect the SNMP Solo to the power supply.
Verify the SNMP Solo Operation
After you complete all configuration settings and connect the SNMP Solo to the network, check the LINK status.
LED Status After Power Up
At first, green and red LEDs do not light.
Green LED begins to pulse randomly, showing network activity.
Five to ten seconds after power up, the red LED flashes rapidly; this indicates that the SNMP Solo is determining which UPS model is connected to your system.
After SNMP Solo determines your UPS model, the red LED turns off.
The red LED pulses once whenever the SNMP
Solo detects a communication failure.
Final Installation | 23 |
