SNMP Solo

To remove a trap receiver from the list, type clear, <space>, and the desired list number at the prompt. Press <enter>.

The top of the screen reflects your changes:

To return to the Main Menu, type 0 at the prompt and press <enter>.

Additional Setup Screen

To set your UPS address, type 4 and press Enter. This will bring up the menu shown in Figure 9.

Figure 9 Additional Setup Screen

You need to set the UPS address. This address should match the address you assigned to the UPS when you installed the UPS. This address will determine which UPS the SNMP adapter communicates with. You can set the address by typing

2<0-127>and pressing Enter. Choose the number 0-127 that corresponds to the UPS address.

18Configuration

Page 24
Image 24
Tripp Lite MT-SE-37/02 owner manual Additional Setup Screen