UPS Interface Cable | Tripp Lite MT-SE-37/02 specification

SNMP Solo

UPS Interface Cable

The manufacture-specific interface cable connects the UPS to the SNMP Solo unit. The table below defines the basic UPS device port configuration:

1	Low Battery	6	Not connected
2	Not Connected	7	Set to Voltage High (+12V)
3	Set to Voltage Low (-12 V)	8	Power Fail
4	Inverter Shutoff	9	Not connected

5Ground

6SNMP Solo Package

Image 12

Tripp Lite MT-SE-37/02 owner manual UPS Interface Cable

Contents

Snmp Solo Limited Warranty Governing Law FCC Compliance Trademarks Conventions Used In This Guide Table of Contents Appendix Snmp Solo Features Introduction Example Network With Snmp Solo Snmp Solo Package Contents Snmp Solo Package Status LEDs Configuration Cable Power SupplyTwo 3.5 Diskettes UPS Interface Cable System Requirements System Requirements Initial Installation Initial Installation Configuration Hardware adapter prior to configuring the device Set IP And Gateway Addresses And MIB System Group IP address Tripp Lite Configuration Set Access Controls Access Controls Set Trap Receivers Trap Receivers Additional Setup Screen Additional Setup Screen Display Settings Reset Configuration to Default To Save and Exit TelNet Options Telnet options Upload Firmware Exit Without Saving Final Installation Verify the Snmp Solo Operation Establish Network Communications Configuring the NMS General Network Management Stations Poll the Device OIDs From the Test Connectivity box SunConnect SunNet Manager Add Snmp Solo Object to the Management Map Poll the Device OIDs Appendix ReferenceCommunities IP Addresses Subnetting and Subnet Masks Class Value of First Network ID Host ID Number Gateways Routing and Filtering Glossary Agent OID Troubleshooting Plugged into their respective ports Placing a Technical Support Call Computer System Technical Support 773 Reference Worksheet