Tyco 4100U-S1 installation manual Power Distribution Interface PDI

Introduction to 4100U-S1 Cabinet, Continued

The Power

Distribution

Interface (PDI)

In the expansion bay, power and data are distributed via the power distribution interface (PDI). The PDI is a wiring board with eight card slots, each of which can accommodate a 4-inch (102 mm) x 5-inch (127 mm) slave card. If 4100-style motherboards are used, they must be mounted over the PDI using a kit of metal standoffs (part number 4100-KT0468).

POWER/COMMS	4100 POWER DISTRIBUTION INTERFACE
	ASSY 566-084
CONNECTORS
(P1-P3)
POWER SOURCE
JUMPERS
(P4, P5)

AUDIO INTERFACE
CONNECTORS	Figure 2-5. The Power Distribution Interface (PDI)
(P6, P7)
(Not used in 4100U-S1)
Mains Outlet
	The rightmost 2” slot in the expansion bay is occupied by a mounting bracket holding a
	single switched General Power Outlet. The fixed AC power wiring must be installed to
	this GPO by a suitably qualified electrician.
	IMPORTANT: AC power must be provided to the 4100U-S1 from a dedicated branch
	circuit.
	The SPS plugs into this GPO, and can be switched off or unplugged for servicing.

2-8