U-Line CLR2160, CLRCO2175 manual Maintenance ICE Maker Self Cleaning Cycle

PROBLEM	POSSIBLE CAUSE	REMEDY
Unit runs but produces very little ice.	Dirty condenser coils	Clean the condenser (See MAINTENANCE; CONDENSER
		CLEANING).
	High air temperature around unit	Surrounding air temperature of over 90°F. Low ice
		production at high temperatures is normal.
	Scale and mineral buildup in unit	Run unit through self cleaning cycle (See
		MAINTENANCE; ICE MAKER: SELF CLEANING CYCLE.
	Inadequate airflow at the front of	Remove items blocking airflow.
	the unit
	Cleaning Cycle recently performed	Allow unit to reach the set temperature to produce ice
		normally.
Poor ice quality (soft or unclear)	Unit is not level.	Level unit (See MAINTENANCE; LEVELING).
	Poor incoming water quality	Consult a qualified plumber to test the water quality
		and recommend appropriate treatment.
	Ice-making system is dirty.	Run unit through self cleaning cycle (See
		MAINTENANCE; ICE MAKER: SELF CLEANING CYCLE).
Unit produces shallow or incomplete	Low water level	Check to see that overflow tube is fully seated.
cubes, or the ice fill pattern on the
	Hot incoming water	Connect the unit to a cold water supply.
evaporator is incomplete.
	Incorrect incoming water pressure	Water pressure must be 20-120 psi.
	Unit is not level.	Level unit (See MAINTENANCE; LEVELING).
Ice is slow to release or does not	Ice-making system is dirty.	Run unit through self cleaning cycle (See
release from the evaporator.		MAINTENANCE; ICE MAKER: SELF CLEANING CYCLE).
	Unit is not level.	Level the unit (See MAINTENANCE: LEVELING).
	Low air temperature around unit	Surrounding air temperature must be at least 50°F.
Ice storage bin full of water	Obstructed drain	Check to see that storage bin drain opening is free from
		obstruction and debris.
Water leaking from under the unit	Supply line leaking	Tighten connection as required.
	Fill tube leaking	Check connection at water valve outlet.
	Bin drain leaking	Check integrity of bin drain hose and clamp.

CLR2160, CLRCO2175 25