U-Line CLR2160, CLRCO2175 manual Initial Startup, Other Site Requirements, Operation

5 Operation

ULIN_0080_A

Figure 2

IMPORTANT

Proper air flow (Figure 2) is required for your unit to operate at its highest efficiently. A grille, located in the base of the unit, must not be blocked at any time, or your unit will not perform as expected.

Initial Startup

All U-Line units are shipped with controls that are preset. No initial adjustments are required.

IMPORTANT

•U-Line recommends the unit be allowed to run overnight prior to loading the Model CLRCO2175 refrigerator with product.

•On ice maker equipped units, it is possible that dirt or scale will dislodge in the water line. Always throw away all ice cubes made during the first two to three hours of operation.

1 2 3 4 5

ULIN_0058_A

Figure 3

To turn the unit on or off, touch and hold the POWER icon (Figure 3, 1) on the display panel for approximately five seconds until the °F symbol flashes and release.

•A small LED above the icon will illuminate to confirm the touch of any controller icon.

•The CLRCO2175 display (Figure 3, 3) will show the unit set-point temperature (38°F) when the unit is on and will show OFF when the unit is off. The CLR2160 display (Figure 3, 3) will show ICE when the unit is on and will show OFF when the unit is off.

•Turning the unit off will override any other control function.

Other Site Requirements

Power Supply

The unit requires a grounded and polarized 115 VAC, 60 Hz, 15A circuit (normal household current). See Electrical Specifications on Page 23.

Water Supply

The unit requires a 1/4-inch OD water supply line and a shut-off valve. For more information see Page 22.

Drain

The unit’s generous 7-inch drain connection height extends the distance the unit can be located from a gravity drain. For more information see Page 19.

IMPORTANT

Drain can NOT be located directly below unit. Unit has a solid base that will not allow unit to drain below itself.

Environmental Requirements

Many U-Line models are designed to operate in harsh outdoor/marine environments. Special considerations include the following:

•The units are designed to operate between 50°F (10°C) and 110°F (40°C). High ambient temperatures (110°F [40°C] or higher) may reduce the unit’s ability to reach low temperatures and may also reduce the ice production rate for those models with icemakers.

•If the ambient temperature is expected to drop below 45°F (7°C), drain all water from the unit to prevent freezing damage not covered by the warranty.

•For best performance, keep the unit out of direct sunlight and away from heat generating equipment.

•For best performance and life outdoors, place under a counter or provide shelter of some kind.

•In climates where high humidity and dew points are present, condensation may appear on outside surfaces. This is considered normal. The condensation will disappear when the humidity drops.

CLR2160, CLRCO2175 7