1 | 2 | 3 | 4 | 5 |
ULIN_0058_A
Figure 9
1.Turn the ice maker off (allowing any ice to melt off of the evaporator) as follows:
a.Touch and hold the ON/OFF button (Figure 9, 1).
b.The display (Figure 9, 3) will switch from ICE to OFF to confirm that the ice maker is off.
2.Remove all ice from the storage bin.
1 |
ULIN_0059_A |
Figure 10
3. Remove inside front cover (Figure 10, 1).
1 |
ULIN_0060_A |
Figure 11
4.Remove the overflow tube (Figure 11, 1) by lifting it up while using a slight back and forth motion to loosen
it from the drain hole. The water in the reservoir will flow down the drain.
5.Replace the overflow tube after all of the water has drained from the reservoir.
6.Start the cleaning cycle as follows:
a.Touch and hold the ON/OFF button (Figure 9, 1).
b.Touch and release the LIGHT button (Figure 9, 4) three times, then release the ON/OFF button (Figure 9, 1).
c.The display (Figure 9, 3) will show “CL” to confirm the beginning of the cleaning cycle.
7.When water begins to flow over the evaporator (approximately three minutes), add one package of U- Line Ice Machine cleaner to the water reservoir.
8.Reinstall inside front cover.
9.When the
10.Clean the storage bin (See INTERIOR CLEANING). Sanitize the bin with a solution of 1 tablespoon of bleach in 1 gallon of warm water. Rinse thoroughly with clean water.
11.To ensure that the drain system is working properly, pour 1 gallon of cool, fresh water into the ice bin. The water should drain freely. If your unit is equipped with a drain pump, it should drain the ice bin.
When ice production resumes, the water fill valve will energize, fill the water reservoir, and
IMPORTANT
•Discard all ice produced in the first harvest.
•Should power to the unit be interrupted during the
Inlet Screen
Interval - Every Twelve Months
The solenoid valve inlet screen must be cleaned at least once each year as follows:
1.Shut off the water at the main supply valve.
2.Pull the unit out to access the back panel.
3.Disconnect electrical power to the unit.
CLR2160, CLRCO2175 | 13 |