U-Line CLRCO2175, CLR2160 manual Leveling

2
3
1	ULIN_0061_A

Figure 12

4.Disconnect the hose connector (Figure 12, 1) from the water solenoid valve (Figure 12, 2).

5.DO NOT remove the inlet screen (Figure 12, 3) from the water solenoid valve. Use a toothbrush to gently clean any sediment from the inlet screen.

6.Re-connect the water supply hose connector (Figure 12, 1) to the water solenoid valve (Figure 12, 2). Tighten the connector securely.

7.Open the water main supply valve and check for leaks at the water hose connection. Ensure that the water supply line is not kinked.

8.Reconnect power to the unit before re-installing.

9.Make sure the drain system is working properly and the drain hose is not pinched or kinked. Pour 1 gallon of cool, fresh water into the ice bin. The water should drain freely. If your unit is equipped with a drain pump, the pump should drain the ice bin.

10.To ensure that the drain system is working properly, pour 1 gallon of cool, fresh water into the ice bin. The water should drain freely. If your unit is equipped with a drain pump, it should drain the ice bin.

Ice Cube Thickness Adjustment

Interval - As Required

Ice thickness adjustments are made using the control panel as follows:

1 3 2

ULIN_0200_A

Figure 13

1.To enter the thickness adjustment mode:

a.Touch and hold the UP ARROW button (Figure 13, 1).

b.Touch and release the DOWN ARROW (Figure 13, 2) button three times, then release the UP ARROW button (Figure 13, 1).

c.The display (Figure 13, 3) will switch to “0” to confirm the thickness adjustment mode has been selected.

2.The factory setting is “0,” and the total range of adjustment is -5 to +5. Use the UP ARROW button to raise the setting and thicken the ice bridge, or the DOWN ARROW button to lower the setting to thin the ice bridge.

IMPORTANT

Ice thickness adjustment should only be made one increment at a time. Allow ice maker production to stabilize for 24 hours before rechecking ice thickness.

3.Touch and release the LIGHT (Figure 13, 4) button key to exit the ice thickness adjustment mode.

4.Remove all ice from the storage bin.

1

ULIN_0063_A

Figure 14

5.Ice cubes in any given batch will vary, so it is necessary to choose cubes from the sample area (Figure 14, 1) for comparison when making adjustments. If further adjustments are desired, repeat Steps 1 through 4.

Drain Pump

Interval - Not Required

A drain pump, if installed, requires no routine maintenance. To check its operation, pour 1 gallon of cool, fresh water into the ice bin. The drain pump will run and water should drain freely from the bin.

Leveling

IMPORTANT

It is extremely important that Clear Ice models are level. If not level, the ice mold will not fill evenly.

14 CLR2160, CLRCO2175