Charging the Battery Pack, Initial battery charging | Uniden DGA940

Please visit your authorised Uniden dealer to obtain an extra battery pack.

CHARGING THE BATTERY PACK

▼Initial battery charging

Before connecting your the phone for the first time, fully charge the rechargeable battery pack for 15-20 hours without interruption.

1.Place the handset on the base.

2.Make sure that status LED lights.

If the LED doesn’t light, be sure the AC adaptor is plugged in and the handset makes good contact with the base charging contacts.

▼Charging optional battery pack

The base of your phone is equipped with a compartment for charging an extra battery pack for use in your handset. You can obtain an extra battery

pack from your authorised Uniden dealer.

1.Position the battery pack so the contacts are faced up.

2.Slide the battery pack into

the charging compartment until it

locks into place. The compartment has a latch that keeps the battery in place.

3.Fully charge the battery for 24 hours. When charging is complete, lift the latch to remove the battery pack. To install the charged battery into the handset, see INSTALLING THE HANDSET BATTERY PACK, page 14.

In the event of a power failure, your spare battery pack temporarily provides power for the base so you can still use your phone.

INSTALLATION & ADJUSTING

15

Image 18

Uniden DGA940 manual Charging the Battery Pack, Initial battery charging, Charging optional battery pack

Contents

Page Functions Repeat Beltclip Holder Arging Contacts Contents Do not short-circuit the battery PrecautionsPrecaution Before you read anything else, please observe the following Important Safety Instructions Precautions Additional Battery Safety Precautions Important Electrical Considerations Telephone Line Problems Features IntroductionWelcome Included in Your Package Installing Installation Considerations DESK/TABLETOP Installation Set the base on a desk or tabletop with Wall Installation Standard wall plate mounting Direct wall mounting Be careful not to insert the mounting screws Installation & Adjusting Installing the Handset Battery Pack Charging the Battery Pack Initial battery chargingCharging optional battery pack Low battery indicator Cleaning the Battery ContactsSetting the PULSE/TONE Switch With normal usage, your battery should last about one year Handset earpiece volume Adjusting Ringer ToneHandset ringer volume Base ringer volume Remove the slot cover Installing the BeltclipTo attach the beltclip To remove the beltclip To reset the digital security code Headset InstallationRestore power to the base Automatic Digital Code Security Using Making and Receiving CallsBasic phone operation Tone If you are dialing in the pulse modeIf you have Call Waiting service and a Flash and Call Waiting Remove the handset from the base Using the memory location featuresDialing a Number in Memory One touch memory dialing Travelling OUT-OF-RANGE Dial the party or service main numberChain Dialing Pabx Connection Integrated Answering Device Message counter LED turns off Setting the Clock Press skip or repeat Press and hold ogm until you hear Preset messageFollowing message is pre-recorded Your message plays back for your review Setting the Ring Time Selecting the Message Time Selecting a PIN Code To select a PIN Playing Your Messages Repeating a Message Skipping a Message Deleting a Message Recording a Voice Memo Using the Reset ButtonReset button is used to initialise the base computer System returns to Standby Remote Access Away from Home Remote Switch OnRemote Room Monitor Other Functions Function Press Troubleshooting Quick Reference Chart Four minute option System does not Base Unit SpecificationsGeneral Handset Warranty Warranty 1800 632 Uniden Australia Pty Limited Part Code UCZZ01655BZ