Headset Installation, Restore power to the base | Uniden DGA940

Use only the Uniden HS910 headset or Uniden CTA 630 headset.

Keep the headset wire away from handset and

base antennas.

HEADSET INSTALLATION

Your phone may be used with an optional headset, the Uniden HS910 or Uniden CTA 630. To use this feature, simply plug the headset plug into the headset jack. Your phone is ready for hands-free conversations.

If you are using an optional headset, you must still use the handset keypad for phone operations.

AUTOMATIC DIGITAL CODE SECURITY

	To prevent other parties from making unauthorised calls on your phone line, a
	digital code was added to the DGA940. Your phone’s handset and base share this
				INSTALLATION&
	code. This code is randomly set each time you place the handset in the base. If
	1. Restore power to the base.
	the phone experiences a power failure, you must reset the digital security code by
	placing the handset on the base.
	▼ To reset the digital security code			ADJUSTING
	2. Place the handset on the base.			ADJUSTING
	2. Place the handset on the base.
	status LED must light up.
	The digital security code is reset.

19

Image 22

Uniden DGA940 manual Headset Installation, Automatic Digital Code Security, Restore power to the base

Contents

Page Functions Repeat Beltclip Holder Arging Contacts Contents Do not short-circuit the battery PrecautionsPrecaution Before you read anything else, please observe the following Important Safety Instructions Precautions Additional Battery Safety Precautions Important Electrical Considerations Telephone Line Problems Introduction FeaturesWelcome Included in Your Package Installing Installation Considerations DESK/TABLETOP Installation Set the base on a desk or tabletop with Wall Installation Standard wall plate mounting Direct wall mounting Be careful not to insert the mounting screws Installation & Adjusting Installing the Handset Battery Pack Initial battery charging Charging the Battery PackCharging optional battery pack Low battery indicator Cleaning the Battery ContactsSetting the PULSE/TONE Switch With normal usage, your battery should last about one year Handset earpiece volume Adjusting Ringer ToneHandset ringer volume Base ringer volume Remove the slot cover Installing the BeltclipTo attach the beltclip To remove the beltclip To reset the digital security code Headset InstallationRestore power to the base Automatic Digital Code Security Making and Receiving Calls UsingBasic phone operation Tone If you are dialing in the pulse modeIf you have Call Waiting service and a Flash and Call Waiting Remove the handset from the base Using the memory location featuresDialing a Number in Memory One touch memory dialing Travelling OUT-OF-RANGE Dial the party or service main numberChain Dialing Pabx Connection Integrated Answering Device Message counter LED turns off Setting the Clock Press skip or repeat Press and hold ogm until you hear Preset messageFollowing message is pre-recorded Your message plays back for your review Setting the Ring Time Selecting the Message Time Selecting a PIN Code To select a PIN Playing Your Messages Repeating a Message Skipping a Message Deleting a Message Recording a Voice Memo Using the Reset ButtonReset button is used to initialise the base computer System returns to Standby Remote Switch On Remote Access Away from HomeRemote Room Monitor Other Functions Function Press Troubleshooting Quick Reference Chart Four minute option System does not Base Unit SpecificationsGeneral Handset Warranty Warranty 1800 632 Uniden Australia Pty Limited Part Code UCZZ01655BZ