Changing the Digital Security Code
The digital security code is an identif ication code used to connect the handset and the base unit. Normally, setting the code is not necessary.
The f irst time you charge your handset, the security code is automatically set. (See page 4.) In the rare situation that you suspect another cordless telephone is using the same security code, you can change the code.
1) Remove the handset from the base unit.
2) Press and hold intercom on the base.
3)The handset is emitting the paging sound place the handset on the base unit. While holding intercom for at least 3 seconds, the paging sound stops. Leave the handset on the base for more than 3 seconds or until the status LED stops flashing. A random, new security code is set.
note
•If the handset battery pack is completely discharged or the battery pack is removed, the digital security code will be lost. If this happens, a new security code
Installing the Beltclip
To attach the beltclip
Insert the beltclip into the holes on each side of the handset. Press down until it clicks.
To remove the beltclip
Pull both sides of the beltclip to release the tabs from the holes.
Headset Installation
Your phone may be used with an optional headset, the Uniden HS910. To use this feature, insert headset plug into the headset jack. Your phone is ready for
If you are using an optional headset, you must still use the handset keypad for phone operations.
is set automatically next time the battery pack is charged.
•If the beltclip is attached, you can only charge the handset in the face down position.
•Use only Uniden HS910 headset specifically designed for Uniden phones.
ADDITIONAL INFORMATION
A D D I T I O N A L I N F O R M AT I O N [ 29 ]
