Uniden EXP 9100 Handset Controls & Functions

Handset Controls & Functions

Hold Button

Volume and

Ringer Volume

Button

Handset

Antenna

Talk Button

Earpiece

Tone Button

Memory Button

One-Touch Buttons

Mute Button

Intercom Button

Monitor Button

Monitor Speaker

Microphone

Flash and Ringer Tone

Button

Redial/Pause Button

Ring On

Battery Save

Switch

1 – 9, 0, ,

# Buttons

RING

BATT

SAVE

Contents

Main Table of Contents Important Safety Instructions SAVE THESE INSTRUCTIONS About Your EXP 9100 please read this Operating Guide thoroughly Unpacking FCC Requirements EXP 9100 Features UltraClear Plus automatically AutoTalk Auto Channel Scan Automatic Digital Code Security Auto Channel Scan and Auto Channel Change Spread Spectrum Technology Auto Power Control Installing Your EXP 9100 Selecting the Installation Location Connecting the Telephone Line NOTE: You can connect the Telephone Line Cord to either jack. Installing the Base Unit on a Desk or Tabletop Use only the AC Adapter supplied with the Mounting the Base Unit on a Wall Use only the AC Adapter supplied with the Use only the AC Adapter supplied with the Installing the Battery Pack (BT-9100) The Battery Pack is keyed to fit so the electrical contacts touch the Handsets electrical contacts. Page CONTACTS CONTACTS Using Your EXP 9100 NOTE: The Preparing the Base Unit and Handset LED and keypad lights flash when the Handset receives a call regardless of the switch position. AutoTalk NOTE: The LED flashes and there is a slight delay while the Spread Spectrum Technology in your sets up a digital link between the Handset and the Base Unit. Example: Special Features NOTE: If any other key is pressed before Intercom. the phone will not redial the last number. Using Your EXP 9100 Memory The After pressing button counts as one digit. Using your EXP 9100 Intercom switch on the Handset must be in the position. The Base Unit switch must be set to either . Using the EXP 9100 as a Room Monitor NOTE: Press on the Handset to adjust the earpiece volume to loud or soft. on the Handset to adjust the Monitor Speaker volume to loud or soft. Troubleshooting Do not attempt to service this unit yourself. All service must be done by qualified service personnel. Problem Suggestion Important Electrical Considerations Note: Please do not attempt to unplug any appliance during an electrical storm. Range Telephone Line Problems Radio Interference Specifications Specifications shown are typical and subject to change without notice Page PRECAUTIONS Before you read anything else, please observe the following: WARNING! NICKEL-CADMIUM BATTERY WARNING Nickel-Cadmium Battery Disposal One Year Limited Warranty Page Base Unit Controls & Functions Handset Controls & Functions Hold Button Redial/Pause Button Monitor Button Flash and Ringer Tone Button