press E. Select 3: MODE for the receiver mode choices and then press E. Select

4:ALPHA TAG to enter an alpha tag using the VFO control.

Search Hold Feature

1. Press HOLD/at anytime to stop the search.

2. Press HOLD/to move to the next higher frequency.

––– OR –––

Press LIMIT/to move down to the previous frequency.

3. Press SRCH to resume searching.

Data Skip

A scanner will normally stop on any transmission it receives. This means the UBC780XLT will occasionally stop on data signals and unmodulated transmissions. You can automatically skip many of these types of transmissions during search. To activate the data skip feature, enter into the menu mode.

1. Press MENU.

2. Press or to select SYSTEM DATA and then press E.

3. Press or to select DATA SKIP and then press E.

4. Set to ON using , or VFO and then press E. DATA appears on the display.

When data skip is active, your scanner may pause momentarily on an unwanted signal but will resume searching in 2 or 3 seconds. Data Skip does not function during AM/WFM band scan, chain search, or SVC search, Priority Scan, and Trunking Mode.

Frequency Skip

If a particular frequency continues to interrupt search scanning, it is possible to set your scanner to skip the frequency.

To skip over a frequency, press L/O when stopping at the frequency you want to skip.

Note: • You can program up to 200 skip frequencies. The 201st skip frequency entered causes the first skipped frequency to unlock.

• If all frequencies in the search range are set to

 

skip, it moves to Search hold mode.

MUTE

To resume searching, do as follows:

 

1)Cancel the frequency skip set, or

2)Reset the search frequency range.

To cancel all skipped frequencies, press and hold L/O for 2 seconds.

27

Page 37
Image 37
Uniden UBC780XLT manual Search Hold Feature, Data Skip, Frequency Skip