Unitech MR350MKII manual Download Program in Multi-point mode, COM1-4?

	Displays all of the files which are stored in the MR350MKII
(	Program as well as data file)

?MS-Kermit>REMOTE DEL <file name> Deletes a program or data file in the MR350MKII.

Step 7.Press [SHIFT] in conjunction with [F5/*] on MR350MKII to exit from Kermit server mode to Ready mode.

Step 8. Select option “1) RUN” in user command menu and press [F7/? ] key to step through the available downloaded executable object program, then press [E] to confirm for choosing 350TEST.EXE to run, or, type the filename (i.e. 350TEST) directly under system Ready prompt. This program allows you to scan barcode data and send data from the MR350MKII to the PC.

1.9.Download Program in Multi-point mode

A sample program, 485COM.EXE, in the UTILITY disk is for multi-point mode environment testing. Please note in multi-point mode each terminal should be assigned a unique address ID and consistent communication parameters with the PC.

NOTE: Following instructions use Host port to serve multi-point mode.

1)If Host port is RS232, directly connect to RS232 port between PC and MR350MKII

2)If Host port is RS485. Install an RS-485 interface card or an RS232/422 converter to the PC. And cabling the network trunk from RS485 interface to MR350MKII via RS485 port (note a twist-pair cable with 22 or 24 AWG should be used).

3)Set communication parameters including address ID on each MR350MKII properly. (The default values are, 9600 bps, non-parity, 8 data bits, 1 stop bit, address ID ‘A’)

4)Power up the PC and all terminals.

5)Run the test program, 485COM.EXE, on the PC.

CRT screen shall appear the following message:

Terminal type 1>350/360 2>700/870/860:

Typing “1” for selecting MR350,

COM(1-4)?:

Typing “1” for selecting COM1, “2” for COM2.

1-10