Unitech MR350MKII manual Configuration Commands

15.Buzzer Volume (ESC N)

This command can remote changing MR350MKII's buzzer sound.

16.Supervisor password (ESC P)

This command can remote changing MR350MKII's buzzer sound.

17.Get terminal ID (ESC R)

This commcand can get terminal ID. The default terminal ID is "MR350"

18.Get terminal ID and version no (ESC v)

This commcand can get terminal ID and version no. The default terminal ID is "MR350 V4.xx".

4.2.Configuration Commands

Configuration commands from the host always follow the standard host command sequence: ESC, cmd, table. The cmd field actually specifies the object to be configured. The table field contains the data organized in a pre-defined format.

1.Terminal Configuration ( ESC T )

The terminal configuration command has the following format: ESC T termtable

This command takes the data structure "termtable" from the host and writes it to the MR350MKII internal terminal control table. The structure within "termtable" must conform to the TERM_CONFIG typedef (see section 2.5 on page 2-17) specified in the previous section.

The new terminal control table takes effect immediately after the ESC T command has been successfully received.

2.Communication Configuration ( ESC C )

The communication configuration command has the following format: ESC C comtable

This command takes the data structure "comtable" from the host and writes it to one of the two MR350MKII internal communication control tables. The structure within "comtable" must conform to the COM_CONFIG typedef (see section 2.4 on page 2-16) specified in the previous section.

4-61