Vanguard 650 Series Features
Vanguard 650 Series Features
Standard Features | These products offer the following standard features: |
| • Small profile |
| • U or S/T ISDN Interfaces |
| • Full X.25 PAD and Switch support |
| • SNMP management and Telnet/X.28 control port support |
CTP |
|
Data Port 2, a DB25 connector configured as a DCE interface, is used as the CTP for | |
| configuration, reporting, and troubleshooting the 650 Series. To access the CTP you |
| must configure your terminal emulation software to VT100, 9600 bps, 8 bit, no |
| parity, 1 stop bit. |
ISDN Service |
|
The Vanguard 650 Series provides an Integrated Service Digital Network Basic Rate | |
| Interface (ISDN BRI) which, via a connector that supports both RJ11 (ISDN U) and |
| RJ45 (ISDN S/T), offers access to ISDN networks. A substantial set of protocols are |
| supported over ISDN. |
Multiprotocol |
|
Support includes SDLC, Bisync, X.25, Async, IP/IPX, and PPP, as well as many | |
Support | other serial protocols. Refer to the Software Release Notice which accompanied your |
| unit for a complete listing of protocols supported by the Vanguard 650 Series. |
Software Download Chapter 3, Installing and Coldloading 650 Series Software, provides complete Vanguard 650 Series downloading and coldloading instructions.
RFC 877 | RFC 877 encapsulation of IP datagrams over an X.25 network allows for |
| interoperability of Front End Processors (FEPs) that support X.25 and IP traffic as |
| well as router vendors supporting RFC 877/1356. |
|
|
Getting Started |
