Selecting a Predesigned Configuration
Restoring
Configurations
Using Kermit
This table describes how to restore a configuration using Kermit.
Step | Action | Result |
|
|
|
1 | Access the control port, and from | The Configuration Save/Restore |
| the Main menu, select | menu appears. |
| Configuration Save/Restore. |
|
|
|
|
2 | From the Configuration Save/ | Characters such as # N3 appear at |
| Restore menu, select KERMIT | the prompt. |
| Restore Configuration. |
|
|
|
|
3 | Select the name of the CMEM from |
|
| the PC’s disk that you wish to |
|
| restore. |
|
|
|
|
4 | Depending on the communications | After approximately 20 to 30 |
| program installed, the steps for | seconds, you will receive the |
| using Kermit may vary. Follow the | following message: |
| directions to receive a file using | Receive complete: File stored |
| Kermit. | successfully. |
|
|
|
| If... | Then... |
|
|
|
| The transfer failed because too | Try again. |
| much time elapsed. |
|
|
|
|
| The transfer failed due to | Refer to the communications |
| communications program | program documentation for |
| problems. | additional information. |
|
|
|
5Warm boot the node to implement the configuration that was transferred.
Installing and Coldloading 650 Series Software |