Vanguard Managed Solutions Sample Network Topology, Sample 650 Network Topology

Sample Network Topology

Sample Network Topology

Introduction	Figure 1-2shows a sample network topology for the Vanguard 650 Series. This
	example, depicting a State Lottery network, shows the connection for the DMS-100
	ISDN switch. The example assumes that the Lottery Terminal has a 202T four-wire
	interface communicating at 1800 or 2400 bps. If the interface required is V.24, then
	you would configure Port 3 and set the soft switch parameter in the Node Record to a
	value of NONE.
		Note
		Note that the remote 650D does not initiate calls in this example.

FEP

Lottery Host

Site (2)

Network Management

Access Point for

X.42 HP OpenView

Protocol

Network

Management

Station (2)

Timeplex		Timeplex TDM				Vanguard 652D's
TDM		56Kbps X.25 Circuits
		Maximum 2 per 6250		ISDN/X.25 Network One per LATA
		180 Logical Channels					Lottery
			per Circuit	SESS Packet Handler
							Terminal
	Distribution Node			DPN Access
	Facility
				Concentrator	SESS ISDN Switch
							Multiple
				X.75 Circuits ISDN to X.25 Handoff
							28= ISDN BRI
X.42							Lines
Protocol
		Managed		Intermodel	DMS-100 ISDN
			Hub
				Trunks
Analog/Conversion			DPN X.25	DMS Packet Handler Switch		Vanguard 652D's
			Switches with
Multiple	Units		Switch Module and
Modems			Resource Modules Minimum of 2 per LATA				Lottery
Lottery Terminal			Lottery Terminal				Terminal
(Non-ISDN Lines)			(Non-ISDN Lines)
	Modem	Modem

Figure 1-2. Sample 650 Network Topology

1-4 Getting Started