Vanguard Managed Solutions 650 installation manual Software, Introduction, Step

Software

Software

Introduction	This section briefly describes the operating software for Vanguard 650 Series
	devices.

Operating Software The operating software comes in three formats: Base, Boot, and Option. There are a variety of operating software images available for the Vanguard 650 Series. See the Software Release Notice accompanying your product for feature information on available operating software. See the “Installing Software” section in Chapter 3 for information on installing the operating software.

Optional Feature Some options purchased for the Vanguard 650 Series require a Software Access Key

Software (SAK). The SAK enables software options and, if you have purchased an option requiring it, the SAK will be identified on a SAK Acknowledgment Sheet, see Figure 2-1.

If you are required to enter a SAK refer to the following sections.

Enabling a SAK When you purchase a software option, you receive a 20-character Software Authorization Key (SAK) to enable the option. The SAK corresponds to the serial number of your Vanguard 650 Series, so it cannot be used on any other node. To enter the SAK key:

Step Action

1Select Configure ->Software Key Table from the CTP Main menu.

2At the Entry prompt, select a new entry. Make sure you do not overwrite existing SAK entries.

3At the Key Value prompt, type in the 20-character code followed by a semicolon (;) to save the SAK.

4Boot the node.

1-14 Getting Started