VB6000 Reference
Example 2
Connect the +12V Power Output of the VBrick through a switch to the event pin on the COM1 port.
Example 3
Connect COM1 output pin (pin1 RTS or pin2 DTR) through a switch to a COM1 event pin. For this method to work, you must force the desired output pin (RTS or DTR) to On via IWS:
TTo force the desired output pin to On:
1.Go to the Configuration: Passthrough page in IWS.
2.Change COM1 Passthrough State to Responder and click Apply.
3.Change RTS/DTR Control to Force On and click Apply.
4.Change COM1 Passthrough State to Disabled and click Apply.
5.Click Save Config when done.
VBrick Appliance Getting Started Guide | 73 |
