DV360/580 Series Direct Vent Gas Fireplace
2. Place the log overlay. Hold the overlay with the flat | Figure 51 |
side down and large cut out for the middle flame |
|
on the right. Set the overlay on top of the burner |
|
toward the left front inside the stop bracket on |
|
the left end and the bend on the front left of the |
|
burner. (Fig. 49) Rotate the right end of the |
|
overlay clockwise until it makes contact with |
|
the back of the log front right. NOTE: |
|
This is very critical as improper |
|
positioning of the overlay will |
|
affect the flame and the per- |
|
formance of the unit. (Fig. 51) |
|
Log Rear
Figure 52
LG462
Locator Pins
Figure 53
LG463
Glowing Embers
Log Overlay
LG478
3.Place log rear. The rear log sits in the firebox at an angle toward the left over the rear log bracket and the left side of the burner.
(Fig. 49) Set the log on the rear log bracket. The notch on the right side will go over the pilot. Swing the left end of the log toward the front until it makes contact with the stop bracket. Slide the log to the right so the pilot notch on the log makes contact with bend on the left of the pilot bracket. (Fig. 52)
4.Place the glowing embers by building them up lightly between the fettle and the burner tube as- sembly. (Fig. 53)
5.Place the log front left. Set the log by matching the square hole on the bottom with the pins on the overlay. The right side of this log should come in contact with the left andiron. Lay the log at an angle to the left over the fettle. When this log is in place, it must not cover the front left opening of the overlay. (Fig. 54)
26 | 20010667 |
