Vermont Casting DVT44 installation instructions Position the Log Front Middle Right

Chateau™

Figure 46

Log Front

Middle (DVT38)

Figure 47

Log Rear Upper

Middle (DVT44 Only)

LG406

LG407

Log Front Upper Right

12. Position the Log Front Middle Right.

DVT38 only. Hold the log with the pointed end toward the back and the wide end toward the front. Set the rectangular indentation located on the bottom of this log over the third right tine on the grate. Lay the pointed end of the log over the flat area located on the pointed end of the front middle log. (Fig. 46)

DVT44 only. Hold the log with the pointed end toward the back and the wide end toward the front. Set the V-shaped end on the front of this log (split area) on the third right tine on the grate. Lay the pointed end of the log over the flat area located on the pointed end of the front middle log. (Fig. 45)

13.Position the Log Front Right. Hold the log with the pointed end toward the back and Y-branch toward the front. Set the rectangular indentation located on the bottom over the rectangular protrusion located on the right grate log. Lay the pointed end of the log over the notched part of the overlay. When the log is in place, the pointed end is located on the left of the pilot assembly. (Fig. 45 )

14.Position the Log Front Upper Right. Hold the log with notched end toward the front and the pointed end toward the back. Set the notched end over the front right log. Lay the pointed end over the manifold tube located to the right of the burner housing. (Fig. 47)

15.DVT44 only. Position the Log Rear Upper Middle. Hold the log with split detail toward the front and the flat end toward the back. Set the round indentation located on the bottom over

the round protrusion located on the rear left log toward the back. Set the right end of the log on the split end located on the right rear log toward the left. When this log is in place, it sets side to side. (Fig. 47)

NOTE: Refer to Figures 48 and 49 for com- plete logset.

26 20011956