Sun Microsystems X2100 manual Installing the Mounting Brackets Onto the Server

1.4.2Installing the Mounting Brackets Onto the Server

Use this procedure to install the mounting brackets onto the sides of the server.

1.Position a mounting bracket against the chassis so that the slide-rail lock is at the server front, and the three keyed openings on the mounting bracket are aligned with the three locating pins on the side of the chassis.

Mounting-bracket clip

Chassis front

Mounting bracket

Slide-rail lock

FIGURE 1-3Aligning the Mounting Bracket With the Server Chassis

2.With the heads of the three chassis locating pins protruding though the three keyed openings in the mounting bracket, pull the mounting bracket toward the front of the chassis until the mounting-bracket clip locks into place with an audible click. (See FIGURE 1-3.)

3.Verify that the rear locating pin has engaged the mounting-bracket clip. (See

FIGURE 1-3.)

4. Repeat to install the remaining mounting bracket on the other side of the server.

1-6Sun Fire X2100 Server Getting Started Guide • April 2006