Sun Microsystems X2100 manual Installing the Server Into the Slide-Rail Assemblies

FIGURE 1-6Extending the Anti-tip Foot

1.4.4Installing the Server Into the Slide-Rail Assemblies

Use this procedure to install the server chassis, with mounting brackets, into the slide-rail assemblies that are mounted to the rack.

Caution – This procedure requires a minimum of two people because of the weight of the server. Attempting this procedure alone could result in equipment damage or personal injury.

1.Push the slide-rails into the slide-rail assemblies as far as possible.

2.Raise the server so that the rear ends of the mounting brackets are aligned with the slide-rail assemblies that are mounted in the equipment rack. See FIGURE 1-7.

3.Insert the mounting brackets into the slide-rails, and then push the server into the rack until the mounting brackets encounter the slide-rail stops (approximately 12 inches, or 30 cm).

Chapter 1 System Setup 1-9