R

Setting the Stud Welding Pistol

4. Setting the Stud Welding Pistol

4.1Setting the Stud Holder

The stud holders of the Stud Welding Pistols PS-1, PS-3K, PS-0K and PS-1K have the same construction. If long welding studs are used it is, however, due to the short construction form of the Stud Welding Pistols PS-0K and PS-1K necessary to appropriately shorten the stop screw (4) of the stud holders on these Welding Pistols.

1

2

3

4

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1,5

 

 

 

SZ06.0593.012.X

1

Stud

3

Counternut

2

Stud holder

4

Stop screw

If other stud diameters are used, different stud holders matching the stud diameters are required.

Set the stud holder as follows:

Loosen counternut (3)

Insert stud (1) into the stud holder.

The top edge of the stud flange must project over the front edge of the stud holder by about 1.5 mm.

NOTE

The stud must be inserted until it reaches the stop screw (4).

Adjust stop screw (4) in the stud holder by rotating movement until the dimension of 1.5 mm between the top edge of the stud flange and the front edge of the stud holder is reached.

Tighten stop screw (4) with the counternut (3).

4-17

Page 24
Image 24
Vicks PS-3K, PS-0K, PS-1K operating instructions Setting the Stud Welding Pistol, Setting the Stud Holder