4Operation

1.Turn on your source components.

2. Plug the female end of the power cord into the AC receptacle on the rear of the Vision 10/12 (AC 100V ~ 240V).

3. Connect the other end to your AC power source. The power indicator lights blue to indicate that the Vision 10/12 is in “standby” mode.

4.Press the ON button on the remote control to turn on the projector. The power indicator turns off.

5.After a brief warm-up period (approximately 10 seconds), the Vision 10/12 will start projecting.

When the Vision 10/12 is installed upright, you can adjust the projector height or projection angle by turning the four adjustable feet on the bottom of the projector; see Figure 4-1.This is useful for correcting the angle of projection when the projector is placed on an uneven surface or when the screen is at an angle. You can tilt the projector up to five (5) degrees up or down by adjusting the feet.

The feet are connected to threaded bolts; turn them clockwise to raise the projector or counterclockwise to lower it.

Tilting the projector may cause keystone distortion. To correct this, refer

Note

to Keystone Correction on page 45.

 

Figure 4-1. Adjusting the Feet

4.1

Turning on the Power

4.2

Adjusting the Projector Height or Projection Angle

Vidikron Vision Model 10/Model 12 Owner’s Operating Manual

29

Page 39
Image 39
Vidikron Vision 10, Vision 12 manual 4Operation, Turning on the Power, Adjusting the Projector Height or Projection Angle