ViewSonic PJD7382, PJD7400W warranty Controlling the projector through a LAN environment

Controlling the projector through a LAN environment

The projector supports Crestron® software. With correct settings for the LAN Control Settings menu, you can manage the projector from a computer using a web browser when the computer and the projector are properly connected to the same local area network.

LAN

USB

RS 232

(An example of connection)

Configuring the LAN Control Settings

If you are in a DHCP environment:

1.Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector and the other end to the RJ45 port.

2.Press MENU/EXIT on the projector or Menu on the remote control and then press / until the SYSTEM SETUP: Basic menu is highlighted.

3. Press to highlight LAN Control Settings and press MODE/ENTER on the projector or ENTER on the remote control. The LAN Control Settings page is

	displayed.
4.	Press	to highlight DHCP and press / to select On.
5.	Press	to highlight Apply and press MODE/ENTER on the projector or ENTER

on the remote control.

6.Please wait for around 15 - 20 seconds, and then re-enter the LAN Control Settings page. The Projector IP Address, Subnet Mask, Default Gateway, and DNS Server settings will be displayed. Note down the IP address displayed in the Projector IP Address row.

• If the Projector IP Address still does not appear, contact your network administrator.

• If the RJ45 cables are not properly connected, the Projector IP Address, Subnet Mask, Default Gateway, and DNS Server settings will display 0.0.0.0. Make sure the cables are properly connected and perform the procedures above again.

• If you need to connect to the projector in its standby mode, set Power Saving to Off.

If you are in a non-DHCP environment:

1.Repeat steps 1-3 above.

2. Press to highlight DHCP and press/ to select Off.

39