Timing of replacing the lamp
When the Lamp indicator lights up red or a message appears suggesting it is time to replace the lamp, please install a new lamp or consult your dealer. An old lamp may cause a malfunction in the projector and in some instances the lamp may explode.
CAUTION
The Lamp indicator light and Temperature warning light will light up if the lamp becomes too hot. Turn the power off and let the projector cool for 45 minutes. If the Lamp or Temp indicator still lights up after turning the power back on, please contact your dealer. See "Indicators" on page 60 for details.
The following lamp warning displays will remind you to change the lamp.
Status | Message | |
|
| |
Install a new lamp for optimal performance. If the | Notice | |
projector is normally run with Economic selected | Order Replacement Lamp | |
(See "Setting Lamp Mode as Economic" on page | ||
55), you may continue to operate the projector | Lamp > ____ Hours | |
until the next hour lamp warning appears. |
| |
| OK | |
|
| |
A new lamp should be fitted to avoid the | Notice | |
inconvenience when the projector runs out of lamp |
| |
time. | Replace Lamp Soon | |
| Lamp > ____ Hours | |
| OK | |
|
| |
It is strongly recommended that you replace the | Notice | |
lamp at this age. The lamp is a consumable item. | Replace Lamp Now | |
The lamp brightness diminishes with use. This is | ||
normal lamp behavior. You can replace the lamp | Lamp > ____ Hours | |
whenever you notice that the brightness level has | Lamp usage time exceeded | |
significantly diminished. If the lamp is not | OK | |
replaced beforehand, it must be replaced when | ||
| ||
you see this message. |
| |
|
| |
The lamp MUST be replaced before the projector | Notice | |
will operate normally. | Lamp usage time exceeded | |
| ||
| Replace lamp (refer to User Manual) | |
| Then reset lamp timer | |
| OK | |
|
|
55
