3.Contact your ITS administrator for information on the Projector IP Address, Subnet Mask, Default Gateway, and DNS Server settings.
4.Press 
to select the item you want to modify and press MODE/ENTER on the projector or ENTER on the remote control.
5.Press 
/ 
to move the cursor and the press 
/
to enter the value.
6.To save the settings, press MODE/ENTER on the projector or ENTER on the remote control. If you do not want to save the settings, press MENU/EXIT on the projector or Menu on the remote control.
7.Press 
to highlight Apply and press MODE/ENTER on the projector or ENTER on the remote control.
• If the RJ45 cables are not properly connected, the Projector IP Address, Subnet Mask, Default Gateway, and DNS Server settings will display 0.0.0.0. Make sure the cables are properly connected and perform the procedures above again.
•If you wish to connect to the projector in its standby mode, be sure you have selected RJ45 and obtained the Projector IP Address, Subnet Mask, Default Gateway, and DNS Server information when the projector is on.
Controlling the projector through a web browser (e-Con- trol™)
Once you have the correct IP address for the projector and the projector is on or in standby mode, you can use any computer that is on the same local area network to control the projector.
1.Enter the address of the projector in the address bar of your browser and press Enter.
2.The remote network operation page is displayed. This page allows you to operate the projector as if you were using the remote control or control panel on the projector.
You can press 
/ 
to reveal more buttons.
i
ii | i |
|
i
i.These buttons function the same as the ones on the OSD menus or remote control. See "2. PICTURE menu" on page 50 and "Projector" on page 8 for details.
ii.To switch between input signals, click on your desired signal.
•The Menu button can also be used to go back to previous OSD menus, exit and save menu settings.
40
