Set the ducker function to ON or OFF.
When multiple input signals are simultaneously broadcast, the ducker function automatically attenuates input
signals of other channels with lower priority.
The ducker function does not work among the input channels with the same priority level.
The function does not work either unless the relevant input channels are all set for the ducker function,
permitting all the input signals to be mixed and output.
Assign priority levels of 1 – 8 (high to low) to the selected input signals.
The priority level given to each Event is based on the priority level set here.
The signal set to priority level 8 is handled as BGM in Event settings.
It is possible to assign the same priority level to multiple inputs.
When two or more inputs are simultaneously broadcast in the same zone, the input with higher priority takes
precedence. However, when multiple inputs with the same priority are simultaneously broadcast, they are
allowed to go through according to the priority settings (refer to p. 44 "Priority setting").
Set the priority level higher than level 8 for the input channel to be used for broadcast (e.g. paging using the
ZP-001T) that overrides BGM broadcasts.
32
O
UT=
O
UTPU
T
S
E
LECT
Output format setting (when the ZP-001T is used)
Select the paging output.
• OUTPUT SELECT: Sets the 9000 Series amplifiers' output or the T-001T's output as the paging output.
• ZONE SELECT: Sets the ZP-001T's contact output as the paging output.
Note that the Zone Select mode cannot be selected with the current firmware.
Operation mode setting (when the ZP-001T is used)
M
O
DE
=
PA
G
IN
G
P
O
RT
Select the method of activating paging.
• PAGING PORT: Paging is operated if a start signal (no-voltage make signal) is received from the paging
port when the connection between the unit and PABX is established.
• RING SIGNAL: Paging is operated if an IR signal is received when the connection between the unit and
PABX is established. The ZP-001T module functions as a telephone.
ON, OFF (default)
Setting Range
1 – 8 (default: 8, 7 only when ZP-001T is used) Setting Range
OUTPUT SELECT (default)Setting Range
PAGING PORT (default), RING SIGNAL
Setting Range
Priority setting
IN1 PRI
O
RI
T
Y 8
IN1–DUCKER
O
FF
Ducker ON/OFF setting