Volvo XC90 owner manual Erasing HomeLink Buttons, Reprogramming a Single HomeLink Button

02 Instruments and controls

HomeLink® Wireless Control System*

02

Erasing HomeLink Buttons

To erase programming from the three Home- Link buttons (individual buttons cannot be erased but can be “reprogrammed” as outlined below), follow the step noted:

1.Press and hold the two outer HomeLink buttons until the indicator light begins to flash-after 10 seconds.

2.Release both buttons. Do not hold for longer that 20 seconds.

HomeLink is now in the train (or learning) mode and can be programmed at any time beginning with “Programming” - step 1.

Reprogramming a Single HomeLink Button

To program a device to HomeLink using a HomeLink button previously trained, follow these steps:

1.Press and hold the desired HomeLink but- ton. DO NOT release the button.

2.The indicator light will begin to flash after 20 seconds. Without releasing the Home- Link button, proceed with “Programming” - step 1.

For questions or comments, contact HomeLink at: www.homelink.com or 1–800–355–3515.

This device complies with FCC rules part 15 and Industry Canada (IC) RSS-210. Operation is subject to the following two conditions: (1) This device may not cause harmful interfer- ence, and (2) This device must accept any interference that may be received including interference that may cause undesired opera- tion.

NOTE

The transmitter has been tested and com- plies with FCC and IC rules. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the device.2

2The term “IC:” before the certification/registration number only signifies that Industry Canada technical specifications were met.

90* Option/accessory, for more information, see Introduction.