Volvo XC90 owner manual Using HomeLink, Gate Operator/Canadian Programming

02 Instruments and controls

HomeLink® Wireless Control System*

NOTE

Some devices may require you to replace this Programming Step 2 with procedures noted in the “Gate Operator / Canadian Pro- gramming” section. If the HomeLink indica- tor light does not change to a rapidly blink- ing light after performing these steps, con- tact HomeLink at www.homelink.com.

3.Firmly press, hold for five seconds and release the programmed HomeLink but- ton up to two separate times to activate the door. If the door does not activate, press and hold the just-trained HomeLink button and observe the indicator light.

•If the indicator light stays on con- stantly, programming is complete and your device should activate when the HomeLink button is pressed and released.

•If the indicator light blinks rapidly for two seconds and then turns to a con- stant light continue with “Program- ming” steps 4-6to complete the pro- gramming of a rolling code equipped device (most commonly a garage door opener).

4.At the garage door opener receiver (motor- head unit) in the garage, locate the “learn” or “smart” button. This can usually be

found where the hanging antenna wire is attached to the motor-head unit.

5.Firmly press and release the “learn” or “smart” button. (The name and color of the button may vary by manufacturer.) There are 30 seconds to initiate step 6.

6.Return to the vehicle and firmly press, hold for two seconds and release the pro- grammed HomeLink button. Repeat the “press/hold/release” sequence a second time, and, depending on the brand of the garage door opener (or other rolling code equipped device), repeat this sequence a third time to complete the programming process.

HomeLink should now activate your rolling code equipped device.

Gate Operator/Canadian Programming

Canadian radio-frequency laws require trans- mitter signals to “time-out” (or quit) after sev- eral seconds of transmission – which may not be long enough for HomeLink to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to “time-out” in the same manner.

If you live in Canada or you are having difficul- ties programming a gate operator or garage door opener by using the “Programming” pro-

cedures, replace “Programming HomeLink” step 2 with the following:

•Continue to press and hold the HomeLink button while you press and release - every two seconds (“cycle”) your hand- held transmitter until the HomeLink indica- tor light changes from a slow to a rapidly blinking light. Now you may release both the HomeLink and hand-held transmitter buttons.

Proceed with “Programming” step 3 to com- plete.

Using HomeLink

To operate, simply press and release the pro- grammed HomeLink button. Activation will now occur for the trained device (i.e., garage door opener, gate operator, security system, entry door lock, home/office lighting, etc.). For convenience, the hand-held transmitter of the device may also be used at any time. In the event that there are still programming difficul- ties or questions, contact HomeLink at: www.homelink.com.

02

	￿￿
* Option/accessory, for more information, see Introduction.	89