Volvo XC90 owner manual Power door mirrors, Calibrating the compass

02 Instruments and controls

Mirrors

02

2.Press the button on the rear side of the mirror with straightened paperclip or simi- lar object for approximately 3 seconds until ZONE is displayed. The number of the cur- rent magnetic zone will also be displayed.

3.Press the button repeatedly until the num- ber for the desired zone (1 – 15) is dis- played.

C Z

A O

N

L E

C

A

L

G026950

Calibrating the compass

After several seconds, the compass heading will again be displayed, and the change of magnetic zones is complete.

Calibrating the compass

1.Stop the car in a large, open area, away from traffic.

2.Turn off as many electrical devices in the car as possible to avoid interference with the compass (e.g. audio system, etc).

3.Using a pen or similar object, hold the but- ton (on the rear side of the mirror) depressed for at least 6 sec-

onds. "CAL" will be displayed.

4.Drive slowly in a circle at a maximum speed of 5 m.p.h. (8 km/h) until CAL is no longer displayed.

NOTE

This step can also be done by driving nor- mally until CAL is no longer displayed.

Calibration is complete.

Power door mirrors

G029575

The mirror control switches are located on the driver's door armrest.

Driver's side: Press the L button (a light in the switch will light up) to activate the adjustment control and then use this control to adjust the driver's door mirror.

Passenger's door: Press the R button (a light in the switch will light up) and then use the adjustment control to adjust the passenger's door mirror.

After you have adjusted the mirror(s), press the L or R switch again (the light will go out) to deactivate the adjustment control.

84