Getting started
Battery charging
Once you have installed the battery, the screen indicates the battery status (see the table below). If necessary, place the handset in the telephone base or charger to charge the battery. For best performance, keep the handset in the telephone base or charger when not in use. The battery is fully charged after 10 hours of continuous charging. See the table on page 58 for battery operating times.
If the screen is blank or displays Place in charger, you need to charge the handset without interruption for at least 30 minutes to give the handset enough charge to use the telephone for a short time. When the battery is low, the handset displays Low battery along with a flashing 
icon. If you are on a call in low battery mode, the handset plays short beeps to alert you.
The following table summarizes the battery charge indicators and actions to take.
Battery indicators | Battery status | Action | ||||||
|
|
|
|
|
|
|
|
|
The screen is blank, or | Battery has no or | Charge without interruption | ||||||
displays Place in charger | very little charge. The | (about 30 minutes). | ||||||
and |
| flashes. | handset cannot be used. |
| ||||
|
|
|
|
|
|
|
|
|
The screen displays | Battery has enough | Charge without interruption | ||||||
Low battery and |
|
|
| flashes. | charge to be used for a | (about 30 minutes). | ||
|
| |||||||
|
|
|
|
|
|
| short time. |
|
|
|
|
|
|
|
|
|
|
The screen displays | Battery is charged. | To keep the battery charged, | ||||||
HANDSET X. |
| place it in the telephone base | ||||||
|
|
|
|
|
|
|
| or charger when not in use. |
If you place the handset in the telephone base or charger without installing a battery, the screen displays No battery.
After you install your telephone or power returns following a power outage, the handset will prompt you to set the date and time (see page 13). To skip setting the date and time, press OFF/CANCEL.
SET DATE
MM/DD/YY
