Installing WatchGuard System Manager

WatchGuard System Manager includes firewall appliance software and management software to protect your network from attack. You put the Firebox® between the Internet and your trusted computers. You then use the software installed on the management station to configure and to monitor your Firebox.

To install the WatchGuard System Manager software, you must:

Collect your network addresses and information

Select a network configuration mode, if you are using WFS appliance software only. This step is not necessary if you use Fireware appliance software.

Select to install the Management Server, Log Server, and WebBlocker Server on the same computer as your management software, or on a different computer.

Configure the management station

Use the Quick Setup Wizard to make a basic configuration file

Put the Firebox into operation on your network

Note

This chapter gives the default information for a Firebox with a three-interface configuration. If your Firebox has more interfaces, use the same configuration tools and procedures as the instructions for the optional interface to configure the other interfaces.

Installation requirements

Before you install WatchGuard System Manager, make sure that you have these items:

WatchGuard Firebox security device

WatchGuard System Manager CD-ROM

A serial cable (blue)

Three crossover Ethernet cables (red)

Three straight Ethernet cables (green)

Power cable

LiveSecurity Service license key

Collecting network information

License Keys

Collect your license key certificates. WatchGuard System Manager comes with a LiveSecurity Service key that enables your subscription to the LiveSecurity service. For more information about this service, see the “Service and Support” chapter in this guide,

You get the license keys for any optional products when you purchase them. For more information about optional products, see the Configuration Guide for your version of appliance software.

Network addresses

We recommend that you make two tables when you configure your Firebox. Use the first table for your network IP addresses before you put the Firebox into operation.

WatchGuard uses slash notation to show the subnet mask.

User Guide

3

Page 9
Image 9
WatchGuard Technologies Firebox X manual License Keys, Network addresses