![](/images/new-backgrounds/1055642/5564247x1.webp)
14 Manual operation
14.1 Keypad functions in manual mode
All settings and functions of the pump in manual mode are set and controlled by means of ) shows, it indicates that Keypad lock is on (see 14.2 Keypad lock).
Note: A number of the controls listed below are shortcuts to commands which are also available through the Main menu. See 15 Main menu.
A brief single press on each key trig- gers a beep sound (if enabled - see
14.3Keypad beep) and causes the pump to function as follows:
START: starts the pump at the speed and in the direction shown on the dis- play. The rotation symbol will become animated to confirm that the pump is operating. We recommend that the speed is reduced to a minimum (0.1 rpm) before starting the pump.
If the pump is running when START is pressed, it causes the information shown on the manual mode main screen to cycle from revolutions per minute, to flowrate in a choice of units (via a warning screen if flowrate has not been calibrated and if this is the first cycle since
18.9Run time.) This cycle operates when the pump is stopped and when it is running. The default can be altered from within the Setup menu. See 18.3 Display.
24 |