![](/images/new-backgrounds/1055642/55642173x1.webp)
Check that the conical connector sleeve of the element to be fitted is the same colour as the pumphead rotor cap
520RE element loading procedure
Note: The element loading procedure is the same for industrial (pictured) and san- itary elements.
Select an appropriate
Slide the connector
Disengage the rotor clutch by fully depressing the yellow clutch button on the side of the rotor hub and turning the hub a few degrees while the clutch button is still depressed. The rotor can now rotate independently of the gearbox and motor for one full revolution. If the clutch
Feed the tubing element around the pumphead track, turning the rotor as nec- essary. Make sure the tubing is not twisted or pinched between the guide rollers and the track.
Slide the second connector
Check that the element lies in the middle of the track and that the connectior flanges are pushed fully home.
Close the guard, pushing it fully home until the latch engages.
Connect suitable pipework to the pumphead tubing using appropriate connec- tors. See below.
87 |